Walchem WebMaster Manuel d'instructions télécharger pdf (Page 34)

4.6 Communicating with the WebMasterONE

4.6.1 Connection via the USB Port

A USB connection to the WebMasterONE can be made via a temporary cable between a laptop

and the front panel of the controller.

Equipment Required

 An USB cable with the appropriate connectors to connect your computer to the

WebMasterONE.

Features Required in the WebMasterONE

 Any WebMasterONE controller is capable of an USB connection.

Utilities you need to set up on your computer

 You will need the USB driver, which comes with the WebMasterONE. It’s also available on

our Web site under Tech Support > WebMaster/WIND > Downloads and Upgrades. You will

also need the Quick Start Guide which comes with the WebMasterONE, or you can download

it from our Web site under Literature > WebMaster.

Parameters that need to programmed into the WebMasterONE

 The WebMasterONE is capable of this type of communication without any programming by

the user prior to attempting the communication.

Steps Required to Establish a Connection

 Connect the supplied USB cable between the WebMasterONE and your computer.

 Install the driver on your PC by inserting the disc supplied and following the instructions in

the Quick Start Guide. This needs to done only once for each PC that will be used to

communicate with a WebMasterONE controller.

 Go to Control Panel, Network Connections, and locate the new Local Area Connection 2 that

has been created. Click on the Properties button. Highlight Internet Protocol (TCP/IP) then

click Properties. Click Use the following IP address and enter 199.199.199.1. Click OK to

exit. This needs to done only once for each PC that will be used to communicate with a

WebMasterONE controller.

 Open Internet Explorer and type in the address 199.199.199.2. The sign-on screen for the

WebMasterONE will come up.

 The sign-on screen of the WebMasterONE will come up. Type the User Name and Password

(Access Code) in the text boxes and click the Submit button. The default user name is

"webmaster" and the default passwords are "2001" for full access, "2002" for calibration only,

and "2003" for read only. These defaults can and should be changed in the Access Code page.

USB

Hard coded Fixed

IP Address:

199.199.199.2

Web Browser

(Client)

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 179 180

Pas de commentaire

Walchem WebMaster Manuel d'instructions Page 34