Walchem WebMaster Manuel d'instructions télécharger pdf (Page 146)

142

Cell Phone Text Message Addresses

The email message above is in html format and will not be displayed correctly on a cell phone.

The cell phone text message email will be truncated. Data log and summary reports are not sent to

these addresses, only alarm emails.

Address – 4

Address

Type in the text box the addresses for a text message to be sent. Up to four addresses are available.

Email and Text Message Settings

Controller Email Address

The controller needs to be given an email address, which your ISP uses to identify the controller as

having an account, so that the ISP will accept the email that the controller is sending, and route it

to the intended recipient. Type in the text box the controller’s email address.

Send Email Via

If you have both a modem card and an Ethernet card installed, click on the radio button of which

you need to use to send an email notification of an alarm condition, or an automatic report.

Email and Text Message Server Settings

SMTP IP Address

In order for the controller to send an email, the email must first be routed to the SMTP IP address

that the Internet Service Provider specifies. Obtain this address from your ISP and type it into the

text box.

SMTP Port

If the SMTP server being used requires a different port than the standard port 25, enter that in the

text box.

ASMTP Settings

ASMTP User Name

Type in the user name required for authenticated SMTP emails.

ASMTP Password

Type in the password required for authenticated SMTP emails.

Use ASMTP for email

Check the box if your Internet service provider requires authenticated SMTP for its emails.

Communications Status

Gateway Access (VNet activations only)

This field is for information and displays if the controller is connected to the remote server or not

and when the connection was made.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 179 180

Pas de commentaire

Walchem WebMaster Manuel d'instructions Page 146