Walchem WebMaster Manuel d'instructions télécharger pdf (Page 94)

SMTP IP Address

In order for the controller to send an email, the email must first be routed to the SMTP IP address

that the Internet Service Provider specifies. Obtain this address from your ISP and type it into the

text box.

Controller email Address

The controller needs to be given an email address, which your ISP uses to identify the controller as

having an account, so that the ISP will accept the email that the controller is sending, and route it

to the intended recipient. Type in the text box the controller’s email address.

Send Email Via

If you have both a modem card and an Ethernet card installed, click on the radio button of which

you need to use to send an email notification of an alarm condition, or an automatic report.

Pager

Primary Pager No.

If there is a pager that you want to be called in case of an alarm condition, type the telephone

number in this text box.

Primary Pager PIN

Enter the primary pager’s PIN number in this text box.

Secondary Pager No.

If there is another pager that should be used in an alarm condition, type the telephone number in

this text box.

Secondary Pager PIN

Enter the PIN number for the secondary pager in this text box.

PIN Delay

Some pagers make you wait for a message to finish before prompting you to dial the PIN number.

If the pager requires a pause before dialing the PIN number, type the number of seconds to wait

between the answering service picking up and the PIN number being dialed. Any value between 1

and 60 seconds is acceptable.

Controller ID

When the controller calls a pager, it will leave a numeric message that is its phone number. You

can have the controller dial some numbers attached to the end of the phone number to let you

know that this is a controller calling and not some long-lost friend. Type in some code, for

example *999, that will remind you that it is a controller calling.

Ethernet (LAN)

Network Mode

If you have purchased the software to allow networking of controllers via Ethernet, use the pull

down arrow to select the role that this controller will serve on the network. If it is not part of a

network of WebMaster controllers, select “Independent”. If it is the Master, select “Master”. If it is

the Slave, select “Slave”. Once the network mode has been selected, the power to the controller

must be cycled in order for the change to take effect.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 128 129

Pas de commentaire

Walchem WebMaster Manuel d'instructions Page 94